13
1SNC 160 001 M0301
Guide to Using AMS 4.0 Marking Software
Different print options could be set up in the lower part of the
window
7
:
7
Use one Plotter Pen Size only
In order to execute this job, two or more pens to be used might
be indicated. If you like to use one tip size, please check this box
and select the respective Pen.
Use Pen inserted in Pen Holder
Once checked this box, no Pen will be picked up from the Pen
Station. The pen directly inserted into the Pen Holder will be used.
This option could be used, if pens used are different from the EK-
Team Pens, although they might have a HP compatible outside
dimension, but will not t into the Pen Station of the plotter.
Use one Plotter Speed only
In order to execute this job, different speeds (10 to 40 mm per
second) could be selected from the data entry. In order to work
with one speed selection only, please check this box and select
the respective speed.
Print selected tags only
If you check this box, only the tags marked before are subject
to be printed.
• Select a sequence:
Just click in the edit window on the sequence once and it is
marked.
• Select multiple sequences:
Just click in the edit window on the rst sequence once, hold
down the Shift Button and click on the next sequence ones
etc. and all are marked.
• Select single tags:
Hold down the Ctrl Button and just click in the edit window
on the single tag or multiple tags once and they are marked.
Print selected segments only
If you check this box, only the segments marked before are subject
to be printed. Just click in the edit window on the segment once
and it is marked. In order to mark two or more segments, hold
down the Ctrl Button and click on each segment once.
If you print on endless strips, additional adjustments are
subject to be checked.
Insert a cutting line
No
8
: no cutting line is printed
Yes
9
: cutting lines are printed after each tag length
Final
10
: cutting line is printed after the last tag of the whole
strip length
The print job starts with a click on the OK Button.
The software checks again if the selected support plates are
placed on the plotter. If not, a warning message comes up to be
conrmed, either continue or cancel.
In case the already started job should be stopped, please click
on the icon Stop Plot in the menu bar. The printout will be
interrupted and the data (if any left) in the print spooler of the
PC will be deleted.
The plotter turns into the Stop Mode and the internal buffer of
the plotter can be deleted by pressing the Clear buffer Key
11
on the operation panel.
In order to send a new job to the plotter, the plotter must be turned
back into the active mode by pressing the Stop Key
12
once on
the operation panel, the red light turns off at the plotter panel.
Other plotter connected might be different in the operation, please
refer to the instruction manual.
8 10 9
11
12
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels