ABB FPBA-01 Manuel d'utilisateur télécharger pdf (Page 22)

Quick start-up guide

Mechanical and electrical installation

• Insert the FPBA-01 into its specified slot in the drive.

• Fasten the screw.

• Plug the fieldbus connector to the module.

Drive configuration

• Power up the drive.

• The detailed procedure of activating the drive for

communication with the module is dependent on the drive type.

Normally, a parameter must be adjusted to activate the

communication. Refer to the drive documentation for

information on the communication settings. With an ACS350

drive, set parameter 9802 COMM PROT SEL to EXT FBA.

• In the ACS350, parameter group 51 shows the status of the bus

configuration parameters.

• Set the required node address at parameter 5102 NODE

ADDRESS and the required profile at 5105 PROFILE.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 125 126

Pas de commentaire

ABB FPBA-01 Manuel d'utilisateur Page 22