ABB FPBA-01 Manuel d'utilisateur télécharger pdf (Page 27)

Mechanical installation

WARNING! Follow the safety instructions given in this manual and

the drive documentation.

Mounting

The FPBA-01 is to be inserted into its specific position in the drive.

The module is held in place with plastic pins and one screw. The

screw also provides the earthing of the fieldbus cable shield

connected to the module.

On installation of the module, the signal and power connection to

the drive is made through a 20-pin connector. (All drives do not

use all the available signals so the connector on the drive may

have fewer pins.)

Mounting procedure:

• Insert the module carefully into its position on the drive.

• Fasten the screw.

Note: Correct installation of the screw is essential for fulfilling the

EMC requirements and for proper operation of the module.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 125 126

Pas de commentaire

ABB FPBA-01 Manuel d'utilisateur Page 27