ABB RDNA-01 Manuel d'utilisateur télécharger pdf (Page 41)

ACH550-UH User’s Manual 1-37

Control panel

Start-Up Assistant Mode

To start the Start-Up Assistant, follow these steps:

The Start-Up Assistant will guide you through the start-up.

The Start-Up Assistant guides you through the basic programming of a new drive.

(You should familiarize yourself with basic control panel operation and follow the

steps outlined above.) At the first start, the drive automatically suggests entering the

first task, Language Select.The assistant also checks the values entered to prevent

entries that are out of range.

The Start-Up Assistant is divided into tasks. You may activate the tasks one after the

other, as the Start-Up Assistant suggests, or independently.

Note: If you want to set the parameters independently, use the Parameters Mode.

The order of tasks presented by the Start-up Assistant depends on your entries. The

following task list is typical.

Select MENU to enter the main menu

Select ASSISTANTS with the UP/DOWN

buttons and select ENTER.

Scroll to COMMISSION DRIVE with the

UP/DOWN buttons and select SEL.

Change the values suggested by the

assistant to your preferences and then

press SAVE after every change.

Task name Description

Spin the motor • Prompts for control panel display language selection.

• Prompts for motor data.

• Guides user through rotation check.

Commission drive Prompts for motor data.

Application Prompts for application macro selection.

References 1 & 2 • Prompts for the source of speed references 1 and 2.

• Prompts for reference limits.

• Prompts for frequency (or speed) limits.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 347 348

Pas de commentaire

ABB RDNA-01 Manuel d'utilisateur Page 41