ABB FPBA-01 Manuel télécharger pdf (Page 105)

Starting up fieldbus communication and programming the ABB PLC (multi-axis system)

105

Starting up fieldbus communication and

programming the ABB PLC (multi-axis systems)

What this chapter contains

This chapter presents the additional steps compared to the ones in the previous

chapter that you must take during the start-up of the drive fieldbus control with ABB

AC500 PLC and PROFIBUS DP adapter module in a multi-axis system. A system

with two drives is set up here.

Equipment and programs

The equipment and programs used in this chapter are the same as in the previous

chapter of this manual. They are listed under Equipment and programs, page 30.

Tool/Step

Setting up the communication

Proceed in the start-up as described earlier in this manual up to page 50.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 133 134

Pas de commentaire

ABB FPBA-01 Manuel Page 105